DIRECTIONAL -12 LED - SURFACE MOUNT -DUAL COLOR -12-24VDC - AMBER/BLUE

ECCO ED3755AB — Surface-Mount 12-LED Dual-Color Directional Warning Light (Amber / Blue, 12-24 V, 70 Flash Patterns, SAE Class I)

Elevate your lighting setup with the ECCO ED3755AB, a compact yet powerful surface-mount directional LED module. Featuring 12 high-output LEDs, this dual-color light delivers both amber and blue output modes in one housing—ideal for versatile warning patterns. Operating across 12–24 V DC, it supports 70 selectable flash patterns, synchronization capability, and meets SAE Class I directional standards for regulated use. Its slim, rugged design is built to fit in tight spaces while providing high visibility on fleet vehicles, utility rigs, and emergency installations.

Key Features & Specifications

• Dual-color output: Amber / Blue in a single LED module
• 12 LEDs, delivering strong directional output
• Wide 12–24 V DC compatibility, suitable for mixed fleets
• Offers 70 flash patterns including alternation, chases, steady, etc.
• SAE Class I directional configuration for compliance with lighting standards
• Surface-mount form factor, compact for tight mounting locations
• Built to resist environmental stresses with durable sealed housing
• Synchronization support via sync line for coordinated flashing
• Low maintenance, long life LED design

Typical Uses & Advantages

• Use on truck or utility body side panels, cab corners, or rear edges
• Ideal for emergency, fleet, or service vehicles needing flexible warning patterns
• Dual-color output removes need for two separate fixtures
• High pattern count enables customization to match any warning scheme
• Meets regulated directional standards for lawful usage
• Rugged construction suited to daily vehicle use

Installation Tips

• Select a flat, unobstructed location to mount for full directional coverage.
• Use proper grommets or protection when routing wiring to avoid abrasion.
• Fuse power close to source and use correct gauge wiring.
• Ensure solid ground to chassis to avoid flicker or interference.
• Program your desired flash mode before final tightening.
• If using multiple units, wire synchronization per ECCO’s guidelines.
• Inspect periodically for lens clarity, mount security, and wiring integrity.