DIRECTIONAL - LED - 72in OUTLINER PERIMETER BAR - LEFT WIRE EXIT -12VDC - DUAL-COLOR - AMBER/WHITE

ECCO ED3772AW-L — 72″ Dual-Color Directional Outliner / Perimeter LED Bar (Amber / White, Left Wire Exit, 12 V DC)

Make your vehicle stand out from every angle with the ECCO ED3772AW-L, a full-length 72-inch directional outliner bar engineered for perimeter lighting and enhanced visibility. This bar produces both amber and white illumination from the same unit, letting you flex between warning and auxiliary lighting modes. It’s built for 12 V DC systems, features 32 dual-color flash patterns, supports phase synchronization, and is designed with a left-wire exit configuration for clean installations. Housed in a durable powder-coated aluminum frame with sealed LED heads and polycarbonate lenses, the ED3772AW-L is built to perform under rugged conditions.

Key Features & Specifications

• Length & Format: 72″ directional outliner / perimeter bar for maximum coverage
• Dual-Color Output: Amber / White from one bar — ideal for warning + work lighting modes
• Flashing Modes: 32 selectable flash patterns, including steady-burn color, alternation, traffic adviser modes
• Mount / Wiring Exit: Left wire exit design for easier cable routing on many vehicle layouts
• Mounting Capability: Universal surface-mounting for flush integration on running boards, bumpers, body edges
• Housing & Durability: Powder-coated aluminum housing, sealed LED heads, scratch-resistant polycarbonate lens
• Sync / Override Support: Includes wiring for synchronization (Phase 1 / Phase 2), dimming, and steady-burn override modes
• Electrical: 12 V DC nominal; integrated 55″ jacketed cable for ease of installation
• Warranty & Certifications: Backed by ECCO’s 5-year warranty, with rugged build suitable for exterior automotive use

Ideal Use Cases

• Roofline or side perimeter lighting on emergency, service, or fleet vehicles
• Running board or body-edge accent / warning lighting
• Integration with main directional systems for full-vehicle visual presence
• Retrofit installs where a long dual-color bar is needed for coverage

Installation Tips

• Locate a flat, unobstructed mounting surface for optimal illumination.
• Use grommets or sealed routing where the left-exit cable passes through body panels.
• Route cabling away from heat sources, pinch zones, or sharp edges.
• Fuse power near source and run adequate gauge wiring.
• Configure and test flash modes and dual-color transitions before final mounting.
• Ground securely to a clean chassis surface to avoid flicker/noise.
• Periodically inspect lens, mounts, and wiring for integrity, especially in rough terrains.