-
Oversized Vehicle DOT Compliance: Specifically calibrated to satisfy legal federal rear identification lighting requirements for all commercial trucks and trailers measuring over 80 inches wide.
-
Premium Stainless Steel Bracket: Features a rigid, silver-finished stainless steel mounting structure that provides exceptional impact protection and will never rust, crack, or degrade.
-
Space-Saving Low Profile: Slim 16.5-inch rectangular layout is optimized for narrow header channels, vehicle gates, and applications requiring minimal spatial footprint.
-
Epoxy-Encapsulated Electronics: Fully potted internal circuitry and solid-state LED components shield the unit against moisture intrusion, environmental corrosion, and electrical shorts.
-
Vibration-Isolated Contacts: Advanced direct pin-to-circuit board solder points prevent mechanical strain and separate filament failures, making the unit immune to heavy road shock.
-
Ultra-Efficient Power Draw: Draws significantly less current than legacy incandescent bulb bars (only 0.05 Amps at 12V DC), freeing up vital vehicle electrical capacity.
-
Plug-and-Play Kit Assembly: Arrives as a complete installation kit featuring pre-installed PL-10 lamp connections branching into a dual-wire harness equipped with a .180 bullet and ring terminal configuration.
Truck-Lite 15050R – 15 Series, LED, Identification Bar Kit (Rectangular Red Lenses, Stainless Steel Silver Bar, 3 Lights on 6" Centers, 12V)
Fulfill strict DOT and federal safety mandates for oversized commercial vehicles while adding a sleek, premium accent to your fleet with the Truck-Lite 15050R 15 Series LED Red Rectangular Identification Bar Kit. Engineered explicitly for commercial trucks, heavy-duty trailers, dry vans, and vocational vehicle bodies over 80 inches in width, this high-performance 12V light bar features three ultra-bright red Model 15 LED lamps spaced evenly on precise 6-inch center distances.
Built to survive the most punishing long-haul environments, the 15050R replaces vulnerable plastic or painted bars with a heavy-duty, silver-finished stainless steel mounting bracket. The slim, low-profile geometry is tailor-made to integrate seamlessly into tight header panels or narrow rails where space is at an absolute premium. Boasting an entirely solid-state, bulb-free configuration, the internal electronic circuitry is completely encapsulated in a defensive epoxy matrix. This rugged design delivers a sonically sealed lens-to-housing bond that locks out moisture, road chemicals, salt, and intense chassis vibrations, ensuring your fleet stays safe, legal, and visible under any highway condition.
Truck-Lite: 15050R3, 15050RTLT, TL15050R, TRU15050R
Grote: 49182
NAPA: 15050R
Navistar / International Fleetrite: FLTCMID25024R
Fleet Interchanges: Universal upgrade for standard 16.5" commercial 3-light rear tracking identifier setups using a 2-screw metal layout and dual-wire bullet connections.